AKA Project Farfemmuven
A pair of these (or more) are extremely handy to have, but at $130 each the cost would add up fast.
I’m thinking I can build these with some inexpensive angle iron centered around these (or something similar). I’m always down for a project. The images are links to the products.
Every garage should have one of these. Overhead version please.
Perhaps when I build the garage I could make one side taller to accommodate a full size lift.
My original plan was to print my door sticker with the VIN number clear on a transparency. This would simulate the numbers being punch out like the factory sticker. Now I’m wondering if a small punch to make actual holes in the sticker would work well. I found this set, which goes down to 0.5mm.
…or this might be a better option.
I haven’t measured the holes yet, but this may be just crazy enough to work.
…cheaper than a kit????
…just a note to self.
This is kinda what my 48×18 workshop could look like.
Or… maybe an 18×54?
(CRAPPY PHOTOSHOP EDIT)
With getting all things settled in the new house, we might be converting my garage into more living space. If that happens, a larger detached garage would be in order. Something like this would be just what the doctor ordered.
