I’m happy to get this off my list. One step closer to getting the garage Ghia ready.
Electric is Almost Done
I have one more box to wire and the juice will be live. After that, I can start putting my press bench together.
Hobart Handler 190 Unboxing
A Little Help…
Lianna is helping hold the conduit up while I tighten the top. She’s a good assistant.
Time to Power the Beer Fridge
This is a useless outlet 10 feet above the floor. It will be much more useful rerouted to the floor to be used by an auxiliary refrigerator.
Drill Press Bench
Today I got my drill press bench together.
Later I’m going over to the in-laws to pick up the drill and some other stuff like my rolling bench and my daughter’s bike (she’s going nuts without her wheels).
I painted a little bit more on the lofts.
I ordered the bins for the main loft, so the rest of this mess should be organized soon.
Daddy Wants AC
Belt Grinder by Multitool
Here’s a cool attachment from Multitool. It turns nearly any bench grinder into a belt and disc grinder. This could be quite handy to have in the garage.
They come in several sizes. This one is the 36×2 version.
Portable Paint Booths by Mobile Solutions
What do you do when you need a full capable yet temporary paint booth at your location? Rent that bouncy house that was at the last birthday party your kids attended!
Well, not exactly, but along the same idea. Check out the portable paint booths by Mobile Solutions.
Model MES23X15HDLT comes standard with the below features.
- 1 23X15HDLT Fully Enclosed Portable Paint Booth
- 12 Fresh Air Inlets Paint Booth Pads (along with covers)
- 3 Exhaust Portable Paint Spray Booth Filters
- 1 Automobile Entrance
- 2 Employee Entrances
- 2 Spray Equipment Access Panels
- 3 Rapid Air Release Slots
- 4 Emergency Exits
- 8 Tie Down Straps
- 1 Storage Bag
- 2 4000 CFM Air Movers
- 1 Minor Repair Patch Kit
- 1 Serial Number along with Production Date
- 1 Year Limited Manufacture Warranty
The Exhaust filters used exceed the 98% capture efficiency. EPA 6H Rule
3-wire vs 4-wire Branch Feeder
3-wire feeders to detached structures that had no other parallel metallic pathways(eg. conduit, water and gas piping, communication cabling, etc.) were allowed up until the 2008 NEC code cycle.
From then on, 4-wire feeders have been required.
4-wire feeders to panels in attached structures have always been required.
3-wire feeder to detached(no longer allowed as of 2008):
4-wire feeder to detached:
4-wire feeder to attached structure:
